Stop Playing In The Dark
Mod Your Xbox 360 With LED Lights
8" Alpena LED Lights - $15.99
10x8 Plexiglass - $1.97
Pencil
Marker
Hot Glue Sticks
Hot Glue Gun
Dremel
Dremel Cut-Off Wheel Bit
Dremel Sanding Band Bit
5 Point Star Screwdriver Set
Solder Iron
Thin Solder
1. Remove faceplate and sides
2. Undue front and back clips
3. Remove bottom plate
4. Remove silver screws
5. Remove top plate mod window anytime after this step
6. Remove rom drive
7. Remove fan tunnel, fan
8. Remove gold screws
9. Remove power button plate
10. Remove black screws
11. Remove power button circuit board
12. Carefully remove motherboard
13. Carefully place motherboard upside down
14. Test LED lights with solder points
15. Solder black ground wire with top left solder point
16. Solder red positive wire with middle left solder point
1. With Pencil, draw window to be cut
2. With Dremel Cut-Off Bit, cut window out
3. With Dremel Sanding Band, sand window edges
4. With marker, mark edges on plexiglass to be cut off
5. With Dremel Cutter, cut edges off of plexiglass
6. Hot glue plexiglass into window
1. Carefully reinstall motherboard
2. Line up wires under fan area
3. Reinstall fan carefully over wires
4. Reinstall gold screws
5. Reinstall power button circuit board
6. Reinstall black screws
7. Reinstall fan tunnel
8. Reinstall rom drive
9. Hot glue LED lights into place
10. Hot glue excess wire length into open area
11. Place modded top plate into position
12. Reinstall silver screws
13. Place bottom plate into position
14. Clip plates back together
15. Reinstall sides and faceplate
Installation Complete !